Skip to main content

New Found Commences 10,000m, Phase II Drill Program at Queensway South

New Found Gold Corp. (“New Found” or the “Company”) (TSX-V: NFG, NYSE-A: NFGC) is pleased to announce commencement of a Phase II, 10,000m drill program at Queensway South (“QWS”), designed to follow up on results from its inaugural 2022 program that tested early-stage exploration targets along an 18.5km long stretch of the Appleton Fault Zone (“AFZ”), approximately 50km south of the Keats Zone (Figure 1). The inaugural 2022 drill program intersected significant gold mineralization in 27 of 33 drill holes and visible gold in 10 drill holes across four target areas (May 25, 2023). QWS is a contiguous portion of New Found’s 100%-owned Queensway project and covers roughly 65km of strike extension on the regional Appleton and JBP Fault Zones across 1320km2 of the Queensway project’s total area of 1,662km2. QWS is easily accessed via the Trans-Canada Highway and a network of forestry roads.

This press release features multimedia. View the full release here:

Figure 1. Queensway Project Overview (Graphic: Business Wire)

Figure 1. Queensway Project Overview (Graphic: Business Wire)

Drill Program Highlights:

  • The Company is planning follow up drilling at Pauls Pond, an area covering a high concentration of gold anomalies on both sides of the AFZ. Seventeen drillholes were completed in 2022 leading to three new discoveries: “Astronaut”, “Nova” and “Nebula”. Astronaut and Nova are parallel structures located west of the AFZ that have been traced over 1,600m and 250m of strike length, respectively. At Astronaut and Nova, eight out of nine holes drilled contained visible gold, including highlight interval of 19.0 g/t Au over 3.15m in NFGC-QS-22-20. Nebula, the third discovery in the Pauls Pond area, is located on the east side of the AFZ and drill testing of a prominent Au-in-soil anomaly with two holes identified significant mineralization that is associated with a near-surface shear zone that returned an initial highlight result of 3.70 g/t Au over 4.30m in NFGC-QS-22-25 (Figures 1-3).
  • Drilling is also planned at the Devils Pond Trend, located on the east side of the AFZ where 2022 drill testing of two trenched Au-in soil and till anomalies led to two new discoveries, “Devils Pond” and “Devils Pond South”. These zones are located 12km apart and all drillholes at both targets intersected broad domains of highly anomalous gold including highlight intervals of 0.47 g/t Au over 8.00m and 0.37 g/t Au over 28.00m in NFGC-QS-22-15 at Devils Pond and 1.01 g/t Au over 8.80m in NFGC-QS-22-30 at Devils Pond South (Figure 3).
  • Several new high-priority drill targets resulting from ongoing prospecting, mapping, soil, till and grab sampling, and trenching have been developed that will be drill tested during the 2023 Phase II program.

Greg Matheson, COO of New Found, stated: “We’ve been itching to get the drill bit turning back at QWS given the great success of our first program completed in the fall of 2022 (May 25, 2023). From my experience with early-stage exploration projects, it is rare to have this kind of success on an initial pass, with 27 of 33 holes hitting significant gold mineralization. In light of these QWS discoveries being made along trend of the AFZ, the same structure responsible for depositing high concentrations of gold 50km north at Keats and Iceberg, we are keen to see what our second pass of drilling will uncover. Applying knowledge gained from our strong understanding of the mineralization controls at QWN, we aim to rapidly assess these QWS targets with proven potential. With approximately 10,000m of drilling allocated to QWS this summer and an extensive surface exploration program underway consisting of trenching, prospecting, mapping and soil sampling, we are eager to build on what we know of this highly prospective region.”

Queensway 500,000m Drill Program Update

The Company is currently undertaking a 500,000m drill program at Queensway and approximately 48,700m of core is currently pending assay results.

Sampling, Sub-sampling, and Laboratory

All drilling recovers HQ core. Drill core is split in half using a diamond saw or a hydraulic splitter for rare intersections with incompetent core.

A geologist examines the drill core and marks out the intervals to be sampled and the cutting line. Sample lengths are mostly 1.0 metre and adjusted to respect lithological and/or mineralogical contacts and isolate narrow (<1.0m) veins or other structures that may yield higher grades.

Technicians saw the core along the defined cutting line. One-half of the core is kept as a witness sample and the other half is submitted for analysis. Individual sample bags are sealed and placed into totes, which are then sealed and marked with the contents.

New Found has submitted samples for gold determination by fire assay to ALS Canada Ltd. (“ALS”) and by photon assay to MSALABS (“MSA”) since June 2022. ALS and MSA operate under a commercial contract with New Found.

Drill core samples are shipped to ALS for sample preparation in Sudbury, Ontario, Thunder Bay, Ontario, or Moncton, New Brunswick. ALS is an ISO-17025 accredited laboratory for the fire assay method.

Drill core samples are also submitted to MSA in Val-d’Or, Quebec. MSA operates numerous laboratories worldwide and maintains ISO-17025 accreditation for many metal determination methods. Accreditation of the photon assay method at the MSA Val D’Or laboratory is in progress.

At ALS, the entire sample is crushed to approximately 70% passing 2mm. A 3,000-g split is pulverized. “Routine” samples do not have visible gold (VG) identified and are not within a mineralized zone. Routine samples are assayed for gold by 30-g fire assay with an inductively-couple plasma spectrometry (ICP) finish. If the initial 30-g fire assay gold result is over 1 g/t, the remainder of the 3,000-g split is screened at 106 microns for screened metallics assay. For the screened metallics assay, the entire coarse fraction (sized greater than 106 microns) is fire assayed and two splits of the fine fraction (sized less than 106 microns) are fire assayed. The three assays are combined on a weight-averaged basis. Samples that have VG identified or fall within a mineralized interval are automatically submitted for screened metallic assay for gold.

At MSA, the entire sample is crushed to approximately 70% passing 2mm. For “routine” samples that do not have VG identified and are not within a mineralized zone, the samples are riffle split to fill two 450g jars for photon assay. The assays reported from both jars are combined on a weight-averaged basis. If one of the jars assays greater than 1 g/t, the remaining crushed material is weighed into multiple jars and are submitted for photon assay.

For samples that have VG identified or are within a mineralized zone, the entire crushed sample is weighed into multiple jars and are submitted for photon assay. The assays from all jars are combined on a weight-averaged basis.

All samples prepared at ALS or MSA are also analyzed for a multi-element ICP package (ALS method code ME-ICP61) at ALS Vancouver.

Drill program design, Quality Assurance/Quality Control and interpretation of results are performed by qualified persons employing a rigorous Quality Assurance/Quality Control program consistent with industry best practices. Standards and blanks account for a minimum of 10% of the samples in addition to the laboratory’s internal quality assurance programs.

Quality Control data are evaluated on receipt from the laboratories for failures. Appropriate action is taken if assay results for standards and blanks fall outside allowed tolerances. All results stated have passed New Found’s quality control protocols.

New Found’s quality control program also includes submission of the second half of the core for approximately 5% of the drilled intervals. In addition, approximately 1% of sample pulps for mineralized samples are submitted for re-analysis to a second ISO-accredited laboratory for check assays.

The Company does not recognize any factors of drilling, sampling or recovery that could materially affect the accuracy or reliability of the assay data disclosed.

The assay data disclosed in this news release have been verified by the Company’s Qualified Person against the original assay certificates.

The Company notes that it has not completed any economic evaluations of its Queensway Project and that the Queensway Project does not have any resources or reserves.

Qualified Person

The scientific and technical information disclosed in this press release was reviewed and approved by Greg Matheson, P. Geo., Chief Operating Officer, and a Qualified Person as defined under National Instrument 43-101. Mr. Matheson consents to the publication of this press release dated July 26, 2023, by New Found. Mr. Matheson certifies that this press release fairly and accurately represents the scientific and technical information that forms the basis for this press release.

About New Found Gold Corp.

New Found holds a 100% interest in the Queensway Project, located 15km west of Gander, Newfoundland and Labrador, and just 18km from Gander International Airport. The project is intersected by the Trans-Canada Highway and has logging roads crosscutting the project, high voltage electric power lines running through the project area, and easy access to a highly skilled workforce. The Company is currently undertaking a 500,000m drill program at Queensway and is well funded for this program with cash and marketable securities of approximately $47 million as of July 2023.

Please see the Company’s website at and the Company’s SEDAR profile at


New Found acknowledges the financial support of the Junior Exploration Assistance Program, Department of Natural Resources, Government of Newfoundland and Labrador.


To contact the Company, please visit the Company’s website, and make your request through our investor inquiry form. Our management has a pledge to be in touch with any investor inquiries within 24 hours.

Neither the TSX Venture Exchange nor its Regulation Services Provider (as that term is defined in the policies of the TSX Venture Exchange) accepts responsibility for the adequacy or accuracy of this release.

Forward-Looking Statement Cautions

This press release contains certain “forward-looking statements” within the meaning of Canadian securities legislation, relating to exploration, drilling and mineralization on the Company’s Queensway gold project in Newfoundland and Labrador; assay results; the interpretation of drilling and assay results, the results of the drilling program, mineralization and the discovery of zones of high-grade gold mineralization; plans for future exploration and drilling and the timing of same; the merits and potential of the Queensway project; future press releases by the Company; and funding of the drilling program. Although the Company believes that such statements are reasonable, it can give no assurance that such expectations will prove to be correct. Forward-looking statements are statements that are not historical facts; they are generally, but not always, identified by the words “expects”, “plans”, “anticipates”, “believes”, “interpreted”, “intends”, “estimates”, “projects”, “aims”, “suggests”, “indicate”, “often”, “target”, “future”, “likely”, “pending”, “potential”, “goal”, “objective”, “prospective”, “possibly”, “preliminary”, and similar expressions, or that events or conditions “will”, “would”, “may”, “can”, “could” or “should” occur, or are those statements, which, by their nature, refer to future events. The Company cautions that forward-looking statements are based on the beliefs, estimates and opinions of the Company's management on the date the statements are made, and they involve a number of risks and uncertainties. Consequently, there can be no assurances that such statements will prove to be accurate and actual results and future events could differ materially from those anticipated in such statements. Except to the extent required by applicable securities laws and the policies of the TSX Venture Exchange, the Company undertakes no obligation to update these forward-looking statements if management's beliefs, estimates or opinions, or other factors, should change. Factors that could cause future results to differ materially from those anticipated in these forward-looking statements include risks associated with possible accidents and other risks associated with mineral exploration operations, the risk that the Company will encounter unanticipated geological factors, risks associated with the interpretation of assay results and the drilling program, the possibility that the Company may not be able to secure permitting and other governmental clearances necessary to carry out the Company's exploration plans, the risk that the Company will not be able to raise sufficient funds to carry out its business plans, and the risk of political uncertainties and regulatory or legal changes that might interfere with the Company's business and prospects. The reader is urged to refer to the Company's Annual Information Form and Management’s discussion and Analysis, publicly available through the Canadian Securities Administrators' System for Electronic Document Analysis and Retrieval (SEDAR) at for a more complete discussion of such risk factors and their potential effects.


New Found Gold Corp.

Per: “Collin Kettell”

Collin Kettell, Chief Executive Officer

+1 (845) 535-1486

Data & News supplied by
Stock quotes supplied by Barchart
Quotes delayed at least 20 minutes.
By accessing this page, you agree to the following
Privacy Policy and Terms and Conditions.